LiveATC Discussion Forums
Air Traffic Monitoring => Listener Forum => Topic started by: 71sbeetle on October 27, 2006, 11:08:34 AM
-
Does anybody ever listen to KPBI ? just curious, everytime I check, I only see one listener ...
-
count me as a listener
-
KPBI has never had any audio after numerous checks. There is lots of good airline, charter, and private aviation at KPBI so I hope this feed becomes active.
Thanks
JFill
-
you are right, it's weird, Stream Transcoder is still setup the same, I havent changed any of the connections, I can still hear my scanner thru my PC speakers but it doesnt go thru on LiveATC.net anymore ...... what should I start checking on ?
-
Check your recording source in the mixer. Assuming your using winXP
Control Panel..
Sounds and Audio Devices..
Audio..
Sound Recording..
Ensure sound recording is the source that your audio cable from your scanner is plugged into. i.e. Microphone. Also check your recording volume.
-
checked it, it's the correct source (back line in) same as it has always been (I haven't touched it since install)
the cable is still connected and I can hear the scanner thru my PC speakers, the record volume is set all teh way up, I dont understand why it's not working, maybe a bug with the Stream Transcoder ?
-
checked it, it's the correct source (back line in) same as it has always been (I haven't touched it since install)
the cable is still connected and I can hear the scanner thru my PC speakers, the record volume is set all teh way up, I dont understand why it's not working, maybe a bug with the Stream Transcoder ?
Also in Options or Settings (in Stream Transcoder) check that the correct audio device (sound card) is being used. I know it can be switched so you can use a secondary sound card to stream audio, so check to make sure that is on the right sound card.
I don't have a copy of STWin on this computer, but I'll look into it further later tonight when I'm sitting in front of my other computer.
Jason
-
yep that is also set correctly :(
maybe something else is wrong ? you tell me. I am using back line in, which is also line in 1
(http://www.hostdub.com/albums/71sbeetle/LiveATC01.jpg)
(http://www.hostdub.com/albums/71sbeetle/LiveATC02.jpg)
-
any idea ?
-
I would get a simple microphone and try the various line and microphone inputs of the computer to help find which are working and help configure them.
I would suspect a problem with the computer inputs rather than the LiveATC software.
Good Luck
JPhil
-
it works now .... not sure what the problem was ..... :mrgreen: