LiveATC Discussion Forums
Air Traffic Monitoring => Listener Forum => Topic started by: jcl410 on August 15, 2016, 09:11:39 PM
-
Hi -
For the last 5 days or so, KBWI tower has been using 123.75 instead 119.4. They say it's temporary, but for an unknown length of time.
Is there any way to get the receiver tuned to the new freq? (Maybe leave both freqs up on the same receiver? They should only use one at a time.)
Aloha,
John
-
Thanks for the report...that is one of my feeds. Will have to get the new freq programmed into a scan.
-
This issue is now resolved...scanning both those frequencies.
-
Thank you!
Aloha,
John
-
Dave -
Is there any way to get the volume increased on the Tower and Ground feeds? It sounds good, with little background noise; just very sofr.
Thanks,
John
-
I know about that issue...I'll try to get them raised a bit - they are low due to a sound card hardware issue that developed after the install there.