LiveATC Discussion Forums
Air Traffic Monitoring => Feed Setup Pictures => Topic started by: borczm on November 06, 2017, 08:41:27 PM
-
oOps! posted it in the wrong section! I hope this is the right place :)
Here's the setup for ZAU / 3CK /KBUU
It's an ongoing project, but here's the first iteration :)
Two Uniden 355b/n
Two Pi 3
Two sound devices
Linear low noise / filtered power supply
Low noise network switch
Shielded / bonded network cables
RG8x for ZAU
LMR400 for 3CK / BUU
All grounds bonded via 1" flat braid straight to 4 bonded rods outside (also bonded to service ground rod)
(https://farm5.staticflickr.com/4581/38199634572_ba58b3dedb_z.jpg) (https://flic.kr/p/21cz7vb)
Two Centerfire VHF Air band antennas (to be replaced soon)
(https://farm5.staticflickr.com/4563/38176392066_0f7effe0bf_b.jpg) (https://flic.kr/p/21avZjj)
...and because I like my roof, masts, mast supports and antenna bases are grounded to 4 8' roods, spaced 8' apart in a loop and bonded to electrical service grounding rod. (including additional conductor inside of the mast to the base of the antenna)
(https://farm5.staticflickr.com/4572/26455402489_37be501e83_b.jpg) (https://flic.kr/p/GiLRt8)
-
well I guess photobucket is not so great for image hosting... flickr it is then!
-
We use the same sound cards. :-D
Ken
-
This review is the best.