Author Topic: Ready for a code? i think  (Read 11282 times)

Offline CYQG

  • Newbie
  • *
  • Posts: 4
Ready for a code? i think
« on: November 18, 2021, 08:43:22 PM »
Hey all, my local feed went down 30 days ago so I've opted to build one and get it running as i know people local liked to listen to it.. I ended up with a Raspberry Pi4 4GB and used the Nooelec NESDR Smart v4 SDR and a tuned antenna, I've set the Pi up as far as I can go using the provided Image from the LiveATC email I got and then at the bottom it says "LiveATC will then send you a valid config file and further instructions to complete the installation."
is this a generic config file that i can just copy from anyone.. i was rushing to get this built as I'm doing my First Solo flight tomorrow and wanted to have the audio from it.. any help would be great!

yes I've sent 2 emails advising the install was complete and nothing back as of yet..



Offline dave

  • Site Founder
  • Administrator
  • Hero Member
  • *****
  • Posts: 4597
    • LiveATC.net
Re: Ready for a code? i think
« Reply #1 on: November 18, 2021, 08:54:04 PM »
Please check your spam folder - responded to you twice. :-)

Offline CYQG

  • Newbie
  • *
  • Posts: 4
Re: Ready for a code? i think
« Reply #2 on: November 18, 2021, 08:58:15 PM »
Dave, i just got it thank you very much!

Offline CYQG

  • Newbie
  • *
  • Posts: 4
Re: Ready for a code? i think
« Reply #3 on: November 19, 2021, 03:08:55 PM »
I know Dave is busy, just wanted to know if anyone here would help me figure out the CronJob part.. hopefully i can get help here without bothering Dave! UPDATE: i managed to get it working !
« Last Edit: November 19, 2021, 04:51:55 PM by CYQG »