Here comes a story: wow...all I wanted to do was put on something new that I got called Static Buster. Easier said then done however I got them hooked up. As I was raising the tilt-up-mast the winch died, it's been acting up...soooo take it off, get the warranty info, go get another, hook it up then get the show on the road. The new winch pulls fast which caused a sch 80 1 1/2" PVC male adaptor to crack, crank it down, pull all the wires out of the pipe, replace the adaptor, let the glue dry for an hour, I know that's not long enough but we gotta go! Crank it up again and about half way up the pipe falls out out the fitting, crank it down, strip the PVC pipe of all the wires, antennas, etc. and NOW I replaced it with galvanized pipe. I hooked up only one antenna facing towards Miami at the moment and ran the ZMA WPB feed through the same antenna. The WPB feed will be so so until I put up the other antenna tomorrow facing towards WPB. Well it only took 10 hours, I figured it would just take the morning...oh well, ya gotta
KEL